Manual and Automatic Points
2 posters
Page 1 of 1
Manual and Automatic Points
Has anyone any comment on this topic at UKTS ....
http://forums.uktrainsim.com/viewtopic.php?f=242&t=144943
.... and in particular my post?
http://forums.uktrainsim.com/viewtopic.php?f=242&t=144943
.... and in particular my post?
Can player paths, including paths with reverse points, be written in Activity Editor, which run over areas with a mixture of manual and automatic points (or even all manual points) with the only difference being that the player will be able to change the manual points with "G" when running running the activity? This obviously cannot be done with automatic points.
David
dforrest- Posts : 572
Join date : 2013-01-21
Age : 79
Location : St. Vincent and the Grenadines (and in an earlier life, Hull)
Manual and Automatic Points
Yes, I am doing it all the time when I test coaches for Darwin Smith in Norwood Yard. There is a pre-set path, but I uses manual points to get at different sets of carriages to test their couplings etc.
Good luck.
Roderic
Good luck.
Roderic
RIGFindlay- Posts : 430
Join date : 2014-02-06
Age : 82
Location : Bridport
Re: Manual and Automatic Points
Will the activity run normally if the intention is not for the manual points to be changed by the person running the activity, but just for the activity to run based on the reverse points?
David
dforrest- Posts : 572
Join date : 2013-01-21
Age : 79
Location : St. Vincent and the Grenadines (and in an earlier life, Hull)
Re: Manual and Automatic Points
Yes.
Roderic
Roderic
RIGFindlay- Posts : 430
Join date : 2014-02-06
Age : 82
Location : Bridport
Similar topics
» Operating points in Explore and Activity mode
» Enabling automatic track sounds for switches, curves, and switches+curves
» Enabling automatic track sounds for switches, curves, and switches+curves
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|